ATAVRRZ200【PDF 7/22 页】KIT DEMO AT86RF230

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录52

3页 4页 5页 6页 [7页]8页 9页 10页 11页

Demonstration Kit User Guide

2-1

5183AZIGB12/07/06

Section 2 Getting Started

This section provides brief instructions to get the Demonstration kit up and running in

the shortest amount of time. Persons reading this section should be familiar with wire-

less networking; otherwise, read section 3 and section 4 for a full description of the

Demonstration kit. This Demonstration kit is fully self-contained, no external hardware

or software is required to conduct the network demonstration. However, in the event

RCB or Display board reprogramming is desired, a PC is required.

2.1

Hardware

assembly

The hardware is assembled by following the steps listed below. Pictures with itemized

callouts are shown in Section 3.

1. Assemble the five RCBs by inserting two AAA batteries.

2. Assemble the Display Board by inserting two AA batteris at the bottom of the

board and connecting any RCB.

2.2

Starting and

using the

network

Network device activity is monitored in two places: the network monitor screen and on

the RCBs designated LED units. The following steps describe device monitoring and

the reconfiguration of network devices over the wireless link.

For more detailed information about the following steps, see Section 5, running the

demonstration.

1. On the Display Board, move the power switch toward the edge of the board

(BAT).

2. When the Atmel splash screen is displayed, move the power switch on the

attached RCB away from the antenna to the ON position.

3. Observe the LCD display indicate channel scan.

4. One at a time, sequentially turn on the four remaining RCBs.

5. Observe as the devices associate with the PAN coordinator (Display) and

populate the Configure screen on the LCD.

6. After all the RCBs are associated, press the SW1 button on the Display

Board to switch to the network monitor screen.

7. Locate the RCBs associated as Switches by checking the MAC address

shown on the Network Monitor screen with the MAC address printed on the

labels attached to each RCB. Observe the LED illumination on an RCB des-

ignated as an LED Unit and also the count increment in the network monitor

screen.

8. Press SW1 to return to the Configure screen.

Note: In the following steps, at a minimum, one RCB must be assigned the function of

a Switch Unit and one RCB must be assigned the function of an LED Unit.

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式